ARM Power V4.01  (Checksum Date Code: :  Fri Sep 15 12:16:59 PDT 2023)

1.	OpenSSL Version 3.0.8 7 Feb 2023
2.	Apache Version 2.4.57
3.	Openssh: 9.3p1
4.	NET-SNMP Version	5.9.1
5.	OpenVPN Version	2.5.7
6.	IPSec Version	5.9.8/K5.4.0
7.	Bash Version	5.0.0(1)-release
8.	RESTful	v1.0, v2 (Aug23)
9.	LDAP Secure Updated to support Windows 2022 Server
10.	NTP Fixed
11.	SNMP V3 with AES128 Priv Protocol fixed
12.	Login Banner-Before Prompt option does not work with newer browsers as the browsers are restricting it. Before prompt will work like after prompt if it detects an unsupported browser in that event
13.	Login Banner option removed from CLI to prevent corruption from 3rd party terminal emulators.
14.	Option to add login banner via the Web GUI added. 
15.	Fixed IETF/RFC4335 Break
16.	ZTP code supports Cisco ISR with option 67
17.	DHCP Client is ON by default on eth0. If DHCP server is not reachable than eth0 has the default IP address 192.168.168.168
18.	Update to TLS 1.3/ OpenSSL 3.x (including cross compile on host PCs)
19.	ZTP Debug Messages added in Logs




Obtaining Firmware Updates:

The most recent updates for our Console Server, Switched PDU and Data Fallback products can be found by visiting https://www.wti.com/pages/software

For older firmware updates, please contact WTI Tech Support at service@wti.com, call our toll free service line at 1-888-280-7227, live chat or fill out a software request form at https://www.wti.com/pages/software

Customer Service Department hours are 8 AM through 5 PM, Pacific Daylight Time.



Installation:

NetReach Centralized Management Software (NetReach), is the preferred method for installing firmware updates on WTI devices.  The NetReach software allows you to manage firmware updates for multiple WTI units from a single interface. 

For a description of the process for managing firmware updates via the NetReach, please refer to the NetReach user's guide, which can be downloaded from the WTI User's Guide Archive at:

https://www.wti.com/pages/manuals-documentation

Note that in order to use the NetReach software, the existing firmware version for the WTI Device(s) must conform to the following standards:

•	Console Server Products (DSM, CPM, and REM Series):  Firmware Version 7.04 or higher.  
•	Switched PDU Products (VMR, NBB, NPS and RPC):  Firmware Version 3.03 or higher.

When upgrading older units that are running firmware versions that are earlier than the standards listed above, it is recommended to use the WTI Centralized Management Software (WMU).  The WMU can be downloaded from WTI's FTP server, located at:

https://www.wti.com/products/wmu-centralized-management-software

Please refer to the WMU user's guide for further instructions.

In addition to the NetReach and WMU, the /UF command can also be used to install firmware upgrades.  For more information on the /UF command, please refer to the user’s guide for your WTI device.