ARM Console V8.07 (Tue Feb  4 12:36:41 PST 2025)
1.	OpenSSL: 3.0.15 3 Sep 2024 (Library: OpenSSL 3.0.15 3 Sep 2024)
2.	OpenSSH: 9.9p1
3.	Apache:  2.4.62
4.	IPSec:  5.9.14/K5.4.0
5.	OpenVPN: 2.5.7    
6.	Bash: 5.0.0(1)-release      
7.	RESTful:  v1.0, v2 (Jan25)
8.	IPSec Version: 5.9.14/K5.4.0
9.	NET-SNMP Version:	 5.9.1
10.	New Alarm & Email notification added for all login/logout activity
11.	Added API call for reboot
12.	Added API call for Cell Signal Strength
13.	WEBGUI has been updated to show Cell Signal Strength
14.	Allow "%cell" and "%any" as left address in VPN
15.	Added Up/Down Scripts for VPN LEFT/RIGHT on web
16.	Added Listen Address under WEBGUI to define virtual interface
17.	Increased Password length for Email Messaging to 128 Characters
18.	Added support for oAuth on Email Messaging
19.	Added support for oAuth on Web Login
20.	Added cell data usage tracking and Alarm
21.	Added SSH Login with cert only (no password required)
22.	Added ability to unlock ports via WEBGUI when Invalid Access Lockout has triggered
23.	Fixed issue where the cell could stop retrying to reconnect under certain conditions
24.	Fixed issue where fallback would not work for LDAP
25.	Fixed issue where WOF could cause HTTPS to stop responding under certain conditions


Obtaining Firmware Updates:

The most recent updates for our Console Server, Switched PDU and Data Fallback products can be found by visiting https://www.wti.com/pages/software

For older firmware updates, please contact WTI Tech Support at service@wti.com, call our toll free service line at 1-888-280-7227, live chat or fill out a software request form at https://www.wti.com/pages/software

Customer Service Department hours are 8 AM through 5 PM, Pacific Daylight Time.



Installation:

NetReach Centralized Management Software (NetReach), is the preferred method for installing firmware updates on WTI devices.  The NetReach software allows you to manage firmware updates for multiple WTI units from a single interface. 

For a description of the process for managing firmware updates via the NetReach, please refer to the NetReach user's guide, which can be downloaded from the WTI User's Guide Archive at:

https://www.wti.com/pages/manuals-documentation

Note that in order to use the NetReach software, the existing firmware version for the WTI Device(s) must conform to the following standards:

•	Console Server Products (DSM, CPM, and REM Series):  Firmware Version 7.04 or higher.  
•	Switched PDU Products (VMR, NBB, NPS and RPC):  Firmware Version 3.03 or higher.

When upgrading older units that are running firmware versions that are earlier than the standards listed above, it is recommended to use the WTI Centralized Management Software (WMU).  The WMU can be downloaded from WTI's FTP server, located at:

https://www.wti.com/products/wmu-centralized-management-software

Please refer to the WMU user's guide for further instructions.

In addition to the NetReach and WMU, the /UF command can also be used to install firmware upgrades.  For more information on the /UF command, please refer to the user’s guide for your WTI device.