ARM Console V8.01 (Wed May  3 11:10:53 PDT 2023) 
1.	OpenSSL:    3.0.8 7 Feb 2023
2.	OpenSSH:    9.2p1
3.	Apache:     2.4.55
4.	IPSec:      5.9.3/K5.4.0
5.	OpenVPN:    2.5.7
6.	bash:       5.0.0(1)-release
7.	RESTful:    v1.0, v2 (Jan23)
8.	IPSec Version:	5.9.8/K5.4.0
9.	NET-SNMP Version:	5.9.1
10. 	Login Banner restricted via the CLI
11.	Login Banner can now be added via the WEB GUI
12.	ZTP code supports Cisco ISR with option 67
13.	Fixed static route issue where it disappeared when the cell was not set as the default gateway
14.	Fallback Terminology is now Bonding in v8.00
15.	DHCP Client is ON by default on eth0. If DHCP server is not reachable than eth0 has the default IP address 192.168.168.168.
16.	Update to OpenSSL 3.0.8, include support for TLS 1.3
17.	API request- Direct Connect Info
18.	Detailed LTE signal strength and quality command (SNR,RSSI,RSRP,RSRQ etc.)
19.	ZTP debug messages in logs
20.	Fixed issue for DHCP that occurred on single ethernet devices and when cell was not set as the primary gateway.


Obtaining Firmware Updates:

The most recent updates for our Console Server, Switched PDU and Data Fallback products can be found by visiting https://www.wti.com/pages/software

For older firmware updates, please contact WTI Tech Support at service@wti.com, call our toll free service line at 1-888-280-7227, live chat or fill out a software request form at https://www.wti.com/pages/software

Customer Service Department hours are 8 AM through 5 PM, Pacific Daylight Time.



Installation:

WTI Centralized Management Software (WMU), is the preferred method for installing firmware updates on WTI devices.  The WMU software allows you to manage firmware updates for multiple WTI units from a single interface. 

For a description of the process for managing firmware updates via the WMU, please refer to the WMU user's guide, which can be downloaded from the WTI User's Guide Archive at:

https://www.wti.com/pages/manuals-documentation

Note that in order to use the WMU software, the existing firmware version for the WTI Device(s) must conform to the following standards:

•	Console Server Products (DSM, CPM, REM, TSM and RSM Series):  Firmware Version v6.23 or higher.  
•	Switched PDU Products (VMR, NBB, NPS, RPC and CCM Series):  Firmware Version 1.48 or higher.
•	Data Fallback Switch Products (AFS Series):  Firmware Version 2.30

When upgrading older units that are running firmware versions that are earlier than the standards listed above, it is recommended to use the WTI Firmware Upgrade Utility.  A zip file that contains the installation files and other documentation for the WTI Firmware Upgrade Utility can be downloaded from WTI's FTP server, located at:

https://ftp.wti.com/pub/TechSupport/Firmware/Upgrade_Utility/

Please refer to the documentation included in the zip file for further instructions.

In addition to the WMU and WTI Firmware Upgrade Utility, the /UF command can also be used to install firmware upgrades.  For more information on the /UF command, please refer to the user’s guide for your WTI device.